Module Overview
INPUT
The Preamp section gives you a Polarity Flip button, a Gain knob to dial in the amount of saturation, a saturation button to switch between two circuits of saturation.
When off, the saturation will be subtle. When on, the saturation will be dense and heavy with a slightly brighter tone!
This section also includes a highpass filter button which when on engages a filter at 75Hz.

EQ
The EQ section contains two knobs and two buttons. The two buttons switch between a bell curve and a shelf.
For the high-frequency section, the bell is at 2kHz and the shelf is at 8kHz.
For the low-frequency section, the bell is at 200Hz and the shelf is at 120Hz.

COMP
The compressor section contains just one knob (threshold).
Use this knob to dial in compression from the fixed settings.
You can also engage auto makeup to compensate for the drop in signal when using extreme settings.
The fixed compressor settings are Attack - 5ms, Release - 300ms, Ratio - 4:1.

TRANSIENT DESIGNER
The Transient Designer section is another knob module.
Turning the knob clockwise will enhance the transients leading to a punchier sound.
Turning the knob counter-clockwise will remove some of the attack and punch of the transients and soften the sound.

EXTRA CONTROLS
The Extra Controls section includes:
Saturation knob to control the level of harmonic saturation in the strip.
Sidechain Filter for the compressor to allow the low-end frequencies to pass through untouched.
Input and Output knobs to control the gain going in and out of the plugin.

home page: https://www.kiiveaudio.com/

DOWNLOAD HERE